Standard export wooden cases or according to the pumps and customer's request
Tianjin, Qingdao, Shanghai, Ningbo...
Within 15 days after get advance payment
12 / 10EE - M Jaw Crusher Mine Machinery Slurry Transport Pump/ bomba de lodos
Horizontal slurry pump benefits
Casing–Casing halves of cast or ductile iron with external reinforcing ribs provide high operating pressure capabilities and an extra measure of safety.
Impeller–front and rear shrouds have pump out vanes that reduce recirculation and seal contamination. Hard metal and moulded elastomer impellers are completely interchangeable. Cast in impeller threads require no inserts or nuts. High efficiency and high head designs are also available.
Throatbush–wear is reduced and maintenance simplified by the use of tapered mating faces to allow positive accurate alignment during assembly and simple removal.
( Note: Approximate performance for clear water,to be used for primary selection only.)
Slurry Pump performance parameters
Clear Water Performance
-Bottom/fly ash, lime grinding
We can produce many kinds of centrifugal slurry pump for mining ,sand and other solids slurry transporting.
Packaging & Shipping
Packaging details: 1. Outside package: standard export wooden cases. 2. Inner package: Stretch film.
Pump fails to discharge any liquid.
Incorrect direction of pump rotation and impeller worn. Suction pipe blocked
Check direction of rotation and replace a new impeller
Power consumption on shaft is excessive
Rotating component is rubbing on a stationary part. Bearing worn. Drive belt tension too tight Flow rate too large Pump speed and ratio too high. Misalignment or unparallel of drive shaft and pump shaft.
Removal the rub Replace the bearing Adjust belt Modify the pump duty and speed. Adjust drive and pump shaft
Bearing is over hearing
Lubricants too much or less. Containing impurities in the lubricant Bearing worn.
Lubricating as requirements. Replace clean lubricant. Replace new bearing.
Bearing has short life.
Misalignment or unparallel of drive and pump motor. Shaft bent. Impeller unbalanced due to wear Foreign object entered into the bearing or insufficient lubrication Incorrect procedure followed in fitting bearings.
Adjusting drive and pump shaft. Replacing shaft. Remove rubbing and replace new impeller Clean the bearing. Replace or refit the bearings.
Pump vibrates or is noisy.
Bearings worn. Impeller unbalanced. Air entered into suction pipe or blocked. Flow rate is noneuniform and pump not primed.
Replaced by new bearings. Replaced by new impeller. Discharge air and remove block. Improve on the pump feeding.